I got this PADD kit from @norbauer a few weeks ago and thought I should finally do a small build thread. Over all, the cast is pretty good, but there are a few pin holes on the back and some around the edges. The biggest bubble/hole is in the top left hand corner, so there will be a little "plastic surgery" needed there.
@Eric_Ardros, @EWilliams, I could use your help in getting the correct dimensions for the 6 white buttons and their proper placement measurements. Also, what material did you use for the ribbed corner plant on?
I know there was a show and tell thread posted by @kertratz showcasing the builds by @EWilliams, so I will using them for some guidance.
(The photo are full resolution. @norbauer, if this an issue I can down size them.)